Är det någon som har provat den här lilla rackaren?
Spec låter bra tyst, autostop/start, 4 bar och billig.
http://www.clasohlson.com/se/Airbrushko ... ft/40-9444
Tyst kompressor
Re: Tyst kompressor
Hej
Den har ingen tank vilket alltid är att rekommendera när man kör airbrush mycket och ofta.
Hade en liknande själv, men trycket blev ojämt och ofta svårt att reglera.
Annars är det säkert en helt ok kompressor.
/Berndt
Den har ingen tank vilket alltid är att rekommendera när man kör airbrush mycket och ofta.
Hade en liknande själv, men trycket blev ojämt och ofta svårt att reglera.
Annars är det säkert en helt ok kompressor.
/Berndt
-
VolshebNik
- Inlägg: 115
- Blev medlem: 21 aug 2012, 12:50
- Namn: Nikolaj
- Ort: Riga, Latvia
Re: Tyst kompressor
Agree with kifobeta. It is better to get compressor with receiver tank min 3L.
I had one like that compressor while ago and still have it. It was my first. And it was working Ok with small Chinese airbrush with 0.2 nozzle.
But when I got another one (BD-183), then I found that new airbrush consumes much more air.
I solved this by getting freon cylinder (tank) for 12L and connecting to. Also I added pressure reducer with manometer
Later I got fridge motor and replace that compressor so it is used only as a backup. Fridge compressor is more powerful, especially on pressure higher than 2-3 bars. That regular compressor performance go down when pressure in the system go up. While fridge compressor performance is not that dependent on that...
Do you already have airbrush? H&S Evolution air consumption is pretty low... And it could fit with this compressor. But be ready that you will not reach more than 2bars (in case you need wet layer of clear coat)
I had one like that compressor while ago and still have it. It was my first. And it was working Ok with small Chinese airbrush with 0.2 nozzle.
But when I got another one (BD-183), then I found that new airbrush consumes much more air.
I solved this by getting freon cylinder (tank) for 12L and connecting to. Also I added pressure reducer with manometer
Later I got fridge motor and replace that compressor so it is used only as a backup. Fridge compressor is more powerful, especially on pressure higher than 2-3 bars. That regular compressor performance go down when pressure in the system go up. While fridge compressor performance is not that dependent on that...
Do you already have airbrush? H&S Evolution air consumption is pretty low... And it could fit with this compressor. But be ready that you will not reach more than 2bars (in case you need wet layer of clear coat)